CERAMIC ADHESIVE AND JOINT FILLERS
CERABOND ACR – 916
It is a dispersion-based ceramic adhesive suitable for vertical and absorbent surfaces in
interior spaces
Description
It is a dispersion-based ceramic adhesive
suitable for vertical and absorbent surfaces
in interior spaces.
DESCRIPTION:
It is a dispersion-based ceramic adhesive
suitable for vertical and absorbent surfaces
in interior spaces.
ADVANTAGES:
It is ready to use.
It has high adherence.
It saves labor.
It is used in ceramic application over
ceramic.
Flexible.
It can be applied to the wooden surface,
thermal insulation board and plasterboard
etc.
USAGE AREAS:
Available use for ceramic, tile, glass mosaic,
marble and etc.
Indoor Applications:
Bath, WC, kitchen, wet areas.
Using on vertical applications.
It should not be used in outdoor horizontal
application that has continuous water
contact
( 23 °C Temparature and 50 % for relative
humidity)
Aderance : ≥ 1,0 N/mm²
Start : ≥ 1,0 N/mm²
After Immerse to Water : ≥ 1,0 N/mm²
After Heat Age : ≥ 1,0 N/mm²
After Freeze-Thaw : ≥ 1,0 N/mm²
Heating Resistane : (-40°C) – (+80°C)
Time for Joint Filler : 18 Hours
***These values were obtained as a result
of laboratory tests, just contain finished
applications according to drying time
performance. Due to differences in
temperature and humidity values in the
construction site, the values may change.
Surface Preparation:
The surface; must be cured, dry and
durable. Loose surface mortar and such as
residues should be cleaned and reached
durable surface.
In case of the necessity the surface should
cleaned mechanically.
Temperature should be between +10 °C
and +30 °C during the application.
Oil, grease, dirt, paint, salt and vomiting that
prevent adhesion should be removed.
If there are segregation, pits and fractures
on the surface, it should be repaired with
the repair mortar prepared by mixing with
DAYMAN REPAIR PLUS and DAYMAN
LATEX C, it should be applied at least 24
hour before,
The over ceramic applications should be
primed by DAYMAN ST PRIMER before the
application.
Preparation Of The Mixture:
The product is ready for use,
Should be mixed by 400 rpm until they
reach homogeneous consistency
As Adhesive:
CERA-BOND ACR 916 – joint trowel is
applied to the surface with hard rubber
tipped mop in 20 minutes.
The tiles should be placed on the adhesive
as leaving a joint gaps.
In order to get the best result from the
application, the tiles should be placed well
with the rubber hammer and the air should
be out.
Proper application for the thickness is 3
mm.