DESCRIPTION:
Cement based, polymer modified, has high
performance, high strength, resistance to
sudden temperature changes, fine grained
surface repair mortar.
ADVANTAGES:
Easy and quick to prepare.
High adherence.
Can be used in structural repairs.
Does not shrink
Provides high resistance to freeze-thaw
cycle.
No shrinkage and shrinkage cracking.
It gives the desired performance in one
layer.
USAGE AREAS:
Repairs,
Repair of concrete surfaces,
When filling rod holes,
Forming corner chamfers,
It can be used in floor preparation before
waterproofing.
( 23 °C Temparature and 50 % for relative
humidity)
Mix Density : 1700 kg/m3
Adherance : 2,1 N/mm²
Application Thickness : 1mm- 10 mm
Workable Time : ~ 45 mint
Final Curing Time: 28 Days
Comressive Strenght 28 days : >40
N/mm²
Temperature Strenght: -20 °C +400°C
Application Temperature : +5°C +35°C
***These values were obtained as a result
of laboratory tests, just contain finished
applications according to drying time
performance. Due to differences in
temperature and humidity values in the
construction site, the values may change
Surface Preparation:
The surface; must be cured, dry and
durable. Loose surface mortar and such as
residues should be cleaned and reached
durable surface.
If necessary, the surface should be cleaned
mechanically.
Remove oil, grease, dirt, paint, and salt
desorption from adhesion.
The floor should be moistened before
application, but should not be allowed to
water ponding.
Preparation Of The Mixture:
Pour 4,5-5 liters of clean water into an
empty, clean bucket, and slowly replenish
REPAIR – 904 and mix with a low speed
mixer at 400 rpm until no lumps remain.
Allow the mortar to rest for 5-10 minutes to
mature.
Mix again for 30 seconds before application.
Using DAYMAN LATEX – C 502 while
preparing the product will increase the
strength of the product and increase the
abrasion resistance.
Application:
The prepared mortar is applied with suitable
equipment.
Min. 1 mm Max 10 mm thickness should be
applied.
Thick applications should be applied in 2 -3
coats.
Wait until complete drying between layers.
The prepared product should be used within
2-3 hours.
Expired mortar should be disposed of.