DESCRIPTION:
Cement-based, fast-setting natural stone,
ceramic, porcelain and granite adhesive
mortar used for horizontal and vertical
applications.
ADVANTAGES:
Easy and fast preparation,
It has high adherence.
It saves labor.
Can be used the joint filler after 3 hours.
USAGE AREAS:
Available use for ceramic, tile, glass mosaic,
marble and etc.
Indoor Applications:
Bath, WC, kitchen, wet areas.
Wall,Flloor
Outdoor Applications:
Floor
( 23 °C Temparature and 50 % for relative
humidity)
Aderance : ≥ 1,0 N/mm²
Start : ≥ 1,0 N/mm²
After Immerse to Water : ≥ 1,0 N/mm²
After Heat Age : ≥ 1,0 N/mm²
After Freeze-Thaw : ≥ 1,0 N/mm²
Heating Resistane : (-40°C) – (+80°C)
Time for Joint Filler : Apprx.3 Hours
Pot Life :20 Minutes
Work Time :15 Minutes
Vertical Joint Filler Time :3 Hours
***These values were obtained as a result
of laboratory tests, just contain finished
applications according to drying time
performance. Due to differences in
temperature and humidity values in the
construction site, the values may change.
Surface Preparation:
The surface; must be cured, dry and
durable. Loose surface mortar and such as
residues should be cleaned and reached
durable surface.
In case of the necessity the surface should
cleaned mechanically.
Temperature should be between +10 °C
and +30 °C during the application.
Oil, grease, dirt, paint, salt and vomiting that
prevent adhesion should be removed.
If there are segregation, pits and fractures
on the surface, it should be repaired with
the repair mortar prepared by mixing with
DAYMAN REPAIR PLUS and DAYMAN
LATEX C, it should be applied at least 24
hour before,
The over ceramic applications should be
primed by DAYMAN ST PRIMER before the
application.
Preparation Of The Mixture:
4,75-5,00 kg water poured in a clean
bucket,
The powder component poured on the
water slowly as 25 kg.Should be mixed by
400 rpm until they reach homogeneous
consistency.
Rest for 3-4 minutes until the mortar
become mature.
Before the application remix for 30 second.
Application:
CERA CEM RAPID 917 – joint trowel is
applied to the surface with hard rubber
tipped mop in 25 minutes.
The tiles should be placed on the adhesive
as leaving a joint gaps.
In order to get the best result from the
application, the tiles should be placed well
with the rubber hammer and the air should
be out.
Proper application for the thickness is 3
mm.