D-BAND 20 -25 -30 – 40
Dilatation tape that made of FPO, used for insulation of building joints and dilatation gaps
in indoor and outdoor spaces.
Description
Dilatation tape that made of FPO, used for
insulation of building joints and dilatation
gaps in indoor and outdoor spaces.
- Usage Areas
- Technical Specifications
- Method of Application
- Additional Information
- Technical Leaflet
- Videos
DESCRIPTION:
Dilatation tape that made of FPO, used for
insulation of building joints and dilatation
gaps in indoor and outdoor spaces.
ADVANTAGES:
Provides permanent waterproofing in
dilatations.
Easy to apply.
Can tolerate dilatation movements.
USAGE AREAS:
Can be used with all sliding waterproofing
products
( 23 °C Temparature and 50 % for relative
humidity)
Roll Length : 20 mt.
Width : 20 – 25 – 30 – 40 cm
Tensile Strength : 4,7 mpa
Elongation : % 580
Break Resistant : 42 N/mm²
Water Pressing Resistant : > 5 bar
Thickness : 1 mm
Width : 20-25-30-40 cm
***These values were obtained as a result
of laboratory tests, just contain finished
applications according to drying time
performance. Due to differences in
temperature and humidity values in the
construction site, the values may change.
Surface Preparation:
The surface; must be cured, dry and
durable. Loose surface mortar and such as
residues should be cleaned and reached
durable surface.
Application:
The product must be installed by DAYMAN
EPO MORTAR or by DAYMAN BOND EPO.
The joints should be adhered by making 10
– 20 cm by making hot air welding.
If the weather is rainy or possible rainy days
the application should not be done,
After the application it must be protected
from strong wind, storm and sun in the first
24 hours,
The application should be made on the part
of the structure that comes into contact with
water.
As the product become slowly cured in the
cold weathers, the second coating must be
done when the first coating is completely
becoming dry.
Ensure that the ambient and floor
temperature is between +5 ° C and +30 ° C.
CLEANING OF INSTRUMENTS:
Should be cleaned by solvent when it wet.
After become dry should be cleaned by the
mechanical ways.
CONSUME:
§ 1,00 mt/mt.
PACKING:
25, 00 mt roll.
SHELF LIFE:
24 months.
SAFETY RECOMMENDATIONS:
Wear suitable protective clothing, protective
gloves, goggles and mask during
application.
Do not smoke during application and work
in well-ventilated areas away from naked
flames.
Hands and eyes must be protected with
gloves and protective glasses. In case of
contact with material, wash eyes with plenty
of water rinse and consult a doctor
immediately.
No food or beverage should be allowed in
the application area.
Store out of reach of children.
For more information please check the
Material Safety Data Sheet.
LIMITATIONS OF LIABILITY:
The information in this technical data sheet
is given according to technical information,
experience and test result.
As GENERALTÜRK A.Ş. cannot control the
usage of the product that used under which
kind of conditions, it does not accept any
responsibility for the application result and
does not guarantee it.
The product suitability for the product user
should be tested and decided accordingly.
All products should be considered in the
advice of those technical knowledge and
equipment.
GENERAL TURK A.Ş cannot accept any
responsibility that occurs because of missuse, it only responsible for the written
suggestions that shows the products where
and how use.
GENERALTÜRK A.Ş. It may change the
properties of its products without
announcement.
The technical data sheet is valid until the
next time it is printed and all previous
technical data sheets invalidate the
description