PACKER 70 – 120
Injection Dowel
Description
Polyurethane and epoxy injection resin for
injection dowel.
DESCRIPTION:
Polyurethane and epoxy injection resin for
injection dowel.
ADVANTAGES:
Economical.
Easy Application.
USAGE AREAS:
It is used for polyurethane and epoxy resin.
( 23 °C Temparature and 50 % for relative
humidity)
Diameter : 14 mm
Lenght : 70 – 120 mm
***These values were obtained as a result
of laboratory tests, just contain finished
applications according to drying time
performance. Due to differences in
temperature and humidity values in the
construction site, the values may change
Surface Preparation:
The surface; must be cured, dry and
durable. Loose surface mortar and such as
residues should be cleaned and reached
durable surface.
All cracks and joints in the area to be
injected should be cleaned.
The cracks larger than 3mm should be
covered with suitable repair materials.
The place of the packers is specified
according to region where the leakage
come from.
The packers (injectors) are placed at an
angle of 45 degrees.
The packers should be installed at a
distance of half the thickness of the
reinforced concrete.
The distance between the packers can be
between 15 cm and 90 cm.
The dust which inside of the holes should
be cleaned.
Preparation Of The Mixture:
The product to be used is prepared
appropriately.
Application:
The prepared packers is applied by injection
pump.
The application pressure can be vary
between 14-200 bars.
The application should be starter from the
first packer.
It starts with low pressure to high pressure
until the resin overflow.
After the resin overflow should be followed
the next packer.
In the injection application, the injected resin
will overflow from the reinforce that has
leakage from the cracks.
After this application the work is done.
LIMITATIONS OF LIABILITY:
The information in this technical data sheet
is given according to technical information,
experience and test result.
As GENERALTÜRK A.Ş. cannot control the
usage of the product that used under which
kind of conditions, it does not accept any
responsibility for the application result and
does not guarantee it.
The product suitability for the product user
should be tested and decided accordingly.
All products should be considered in the
advice of those technical knowledge and
equipment.
GENERAL TURK A.Ş can not accept any
resposibility that occures because of missuse,it only responsible for the written
suggestions that shows the products where
and how use.
GENERALTÜRK A.Ş. It may change the
properties of its products without
announcement.
The technical data sheet is valid until the
next time it is printed and all previous
technical data sheets invalidate the
description